1 / 4
Satsana 5015 with BIQU Microprobe braquet — zdjęcie 1
1 / 4

Satsana 5015 with BIQU Microprobe braquet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Satsana 5015 with BIQU Microprobe braquet merged to the fan duct, making it one piece

Ocena
0 / 5
Polubienia
2
Pobrania
6
Wydruki
0
Wyświetlenia
67
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the famous Satsana single 5015 fan duct for the Ender3 by Eric Anastas

It really bothered me to have to use a additional braquet that mounts on the fan duct as i often needed to get access to the hot end / heat sink / heat break for maintenance and had to unmount everything to proceed with whatever i had to do. Thus i really wanted a two-screws-unmount-process.

So this remix of the Satsana 5015 does exactly that as it merges the braquet with the fan duct, making it one piece.

For print settings, i recommand :

  • Perimeters : 2 or 3

  • Infill : 10% for fan duct and cable cap, and 100% for the braquet for maximum strength (apply modifier)

  • Filament : PETG does the job fine but prefer ABS if you can print it. Don't use PLA

  • Layer height : 0.2 mm

  • Supports : yes but only for critical areas

Assembly is pretty straight forward, just remember to pass the probe cable through the hole in the braquet and plug it before mounting the probe as it will make assembly much easier. If necessary, adjust the height of the whole assembly by moving it up or down then thighten the screws to the back plate.

Offsets to use for config

  • x_offset: -54.7

  • y_offset: -10.0

Note : the braquet may look fragile as it is quite thin, but it's sturdy enough.

Tagi