1 / 7
Rubber Band Powered Airplane: Sporty — zdjęcie 1
1 / 7

Rubber Band Powered Airplane: Sporty

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A fully printable sport free flight model with adjustable wing for balance and tabs for trimming.

Ocena
0 / 5
Polubienia
8
Pobrania
78
Wydruki
0
Wyświetlenia
393
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Share Alike

Inspired by the sport class racing planes, this is a small rubber model for PLA and minimum 250 mm size beds. Model flies fairly well, but due to the drag of the propeller has a very steep glide angle. You'll want to set up for run time rather than torque.

Rubber Bands: I recommend FAI tan rubber from a free flight supplier ( Peck Polymers , FAI Model Supply ). Two loops of 1/16th inch should do well. 1/8 inch will also work, but keep it to one loop. The hook size makes it hard to fit more rubber. Otherwise use what you have, or visit your local office supply source. Avoid using colored rubber bands: they overstress and lose elasticity after a few runs.

Printing: I used basic PLA and 30% infill, and I set the first layer to .16mm for that transparent look. This model depends on a good first layer so make sure the z-offset and extrusion rate are dialed in. I have printed several 'screen door' models, and while they do fly the rigidity is not good.

I have tested LW PLA, and found that the models, while lighter; end up very flexible and don't support as many winds in the motor. If PETG is available, you may want to use it for the propeller and hook assemblies.

Assembly: Wait for parts to cool then carefully remove from the plate.

  1. At the two widthwise grooves in the wings, carefully crease so that the wingtips point upwards (plate side up). The angle should be about 30 degrees. The crease line is not perpendicular to make the angle of the airfoil lower. Add a drop of glue to the crease to hold the angle.

  2. Snap the wing on in the middle of the ridged section. Take care of the hook tabs, they layers are inline with the force. Too much bending can cause them to fail.

  3. Snap in the stabilizer next, flat plate side up.

  4. Push the hook through the hole in the front, add the washer to the pointed end. Pre fit the propeller on and check for free rotation. use a file or hobby knife to adjust the fit as necessary. Apply small amount of glue  to the inner hub of the prop, then push it on the hook concave side towards the tail.

  5. Loop one end of the rubber band (or rubber band chain) around the capstan in the rear. pull that end through the loop to form a hitch. now pull the other end over the hook.

Test Flying: Make a couple of test glides to verify weight and balance by gently tossing the model. If model stalls or undulates while gliding move the wing back. If model lawn darts or dives steeply, move the wing forward. 

Now wind up the model and let it fly. Add aileron trim to correct for any rolling due to torque. Add rudder to set the direction of the turn and up elevator to increase the climb angle. For more information on trimming free flight models read this trimming article at the National Free Flight Society's library. 

Let me know if you have any questions! Shout out to Arty_SC on makerworld for inspiring this project

Tagi