Inventum AC125W 150mm Dual-Hose Intake Adapter > Adjustable for any portable AC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Split 150mm intake adapter for converting an Inventum AC125W (or any) portable AC to a dual-hose setup.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 330
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 150 mm intake adapter for converting an Inventum AC125W (or any) portable air conditioner to a dual-hose setup.
It is based on the idea of adding a separate intake hose to a single-hose portable AC, so the unit can pull condenser air from outside instead of constantly pulling cooled room air out of the room.
This remix is not a direct resize of the original model. I used the original dual-hose upgrade as inspiration, but rebuilt the adapter around my own Inventum AC125W lower rear intake measurements.
The adapter is made for the lower rear intake grille, marked as #10 on the AC. My measured intake plate size is 170 x 270 mm.
Included files:
Lower half of the intake plate
Upper half of the intake plate
Two seam straps
Collar test
OpenScad file
Main features:
150 mm male spigot for a flexible intake hose
Split plate design, so the 270 mm part is easier to print
Printed seam straps to join both halves
M3 screw clearance holes in the straps
Pilot holes for M3 heat-set inserts
Clampable collar section
Raised hose-retention bead
Tapered lead-in to help the hose slide on
Reinforced root ring at the collar base
PETG-oriented dimensions and wall thicknesses
Printing notes:
I designed this around PETG.
Use enough walls/perimeters for strength and heat resistance.
The OpenSCAD defaults assume 4 walls with a 0.6 mm nozzle for the transition/collar walls.
Print the collar test first if you are not sure about your hose fit.
If the seam is too tight, slightly increase the split clearance in the OpenSCAD file.
Hardware:
M3 screws
M3 heat-set inserts
Hose clamp for the 150 mm flexible duct
Foam/rubber gasket or sealing tape around the intake plate
Important:
This is a DIY modification for a portable air conditioner. Make sure the added intake hose does not restrict airflow, and keep the AC’s intake clear while in use.
This made the AC way more efficient. My other rooms no longer heat up, and I can safely say my own room is actually freezing now.
