Sony WF 1000 XM3 Dockingstation (for Amazon Basics Cable)

Hello everyone,

I was looking for a dockingstation for my Sony wf-1000xm3 wireless earbuds but couldn´t find a fitting thing for me.

My plan was to have a cover on the backside to hold the cable in place (and to look nice and even of course).

The cable I´m using is a USB-C to USB-A from Amazon Basics. So the whole point is holding this particular cable in place. Also should the design be clean and don´t waste to much material.

______________________________________________________________________

Things you need:

• The Amazon Basic USB-C cable (the plug is 10,60x5,40mm)
• 2x M3x10mm countersunk screw (8mm length should work too)
• About 30g of material
   

While I was designing this thing I tested the cable fitting with a cut out version of it and this could be a super micro design to mount on a wall with much less material and way shorter printing time. So If you´re think you want that version, drop me a comment.

I would be pleased to see a make of this one.

______________________________________________________________________

After Printing:

1. Slide the plug into the backside of the dock and push it all the way in.
2. Take your case and plug it in.
3. Push the case all the way down until it´s flush with the radius inside the dock. Now you have the correct height of the plug.
4. Screw the cover on and you´re ready to go.

Double-sided tape works great for mounting. It´s strong enough to undock the case without holding the dockingstation.

If the plug should get loose over time, a drop of superglue could make the trick.
Update after 10 months of daily docking: still fits like on day one. No superglue needed.
 

If you have any questions, feel free to ask.