KILKBOT (Zing) Double Open Ended Joint
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for a Kilkbot (action figure by Zing), it's double open ended. Print with PETG or stronger. Clicks well.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 99
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution — Noncommercial
KLIKBOT Double Joint Replacement
This is a replacement double open-ended joint designed for the Zing KLIKBOT action figures. It replaces the original snap-fit connector that can sometimes crack or break after repeated posing.
The replacement is designed to restore articulation while maintaining a secure snap fit, allowing your KLIKBOT to get back into action instead of ending up in the spare parts box.
Features
Direct replacement for the original double-ended joint.
Restores movement and articulation.
Quick and easy to install.
Ideal for repairing broken KLIKBOT figures rather than replacing them.
Printing Recommendations
Material: PETG recommended for durability (PLA also works but may wear sooner).
Layer height: 0.15 mm (0.2mm should be ok, but smaller for better clicking articulation)
100% infill for maximum strength.
Mild supports required, build-plate only.
If the fit is slightly tight, gently flex the part a few times before installation. Every printer is a little different, so you may need to adjust your extrusion or horizontal expansion settings for the perfect snap fit.
If this part helped save one of your KLIKBOTs, I'd love to see your repair. Feel free to post a make!