ZIMZ Snapmaker U1 MCU and Stepper Cooling Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a cooling mod to allow you to print with a 60C heated chamber over long periods and keep low mcu /stepper temps
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 423
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Disclaimer: This guide is unofficial. Attempting this modification may void your Snapmaker warranty, and I take no responsibility for any damage to your printer or property that results from following it.
This mod is an intermediate mod for your U1 printer and requires the user to be comfortable with soldering, wiring, adding heat inserts to parts and partially disassembling and re-assembling their U1. It requires some additional parts and pieces to work but once complete you can achieve much lower MCU and Stepper temps while printing higher temp material (ASA, ABS, PC, etc). Before this mod, I’d see 90C stepper temps and 80C board temps during ASA and ABS prints..
Credits
Thank you to the following for the help, models and knowledge!
Cheeky_b52, wildtang3nt, acemasr, aim6mac, dub, plastikman, Luke007
*The After photo is at 2 hour of a 3 hour print. 60C enclosed chamber printing ABS.
Guide Link
BOM Link