Miata Rollbar Trim Rings - Hard Dog Deuce in an NA
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Provide a more finished look after installing a rollbar in your car.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Having installed a real (non-decorative) roll bar in our 1991 Mazda Miata, I wanted something to give it a more finished look and conceal the butchery that had occurred cutting the parcel shelf and its carpet to fit it. There are aftermarket trim rings that you can buy, some even specific to the roll bar they're designed to fit, but they're not the easiest to find and are all pretty expensive for what they are. They also wouldn't cover the sloping bulkhead in our car. This is the kind of thing that 3D printing is made for!
These trim rings are a clean-sheet design, so no attributes to others are required. I do ask however that this design or any of its parts not be used commercially and that any remixes do provide attribution and continue that license structure. I've provided this for free so please pay it forward!
A complete set for an NA Miata with the Hard Dog Deuce bar requires this model to be printed twice. If you're wondering why there isn't a third ring for the outermost front tubes, it's because there is very little clearance between the tubing and the Miata's seatbelt towers, and with the seatbacks up the point where the tubing meets the parcel shelf is mostly hidden anyway. You could easily print an extra set of the rear rings and modify them as desired to cover those spots. (The rear rings could likely fit many applications.)
Some important notes:
As with any item intended for use in an automotive environment, PETG or ABS is recommended to provide adequate heat and UV tolerance. (We've used PETG in this car successfully before and the rings pictured are PETG.)
These are designed and intended for NA Miatas and Bethania Garage's Hard Dog Deuce roll bar. The front rings have a sloping extension that is meant to fit the curved front of that model's parcel shelf, so may not work properly with NB Miatas or different roll bars. The rear rings should be far more versatile.
The roll bar that these were designed to fit uses 1-3/4 inch tubing, so these trim rings are sized to fit that diameter pipe. In theory you could resize the print for different sized tubing.
The inner bore has a 10º taper to accommodate angled bars and seems to work fine with the rear bars in our car that are angled at more than 10º. Greater angles would require manual clearancing to accommodate, up to the limits of the design's size.
These will print without supports, however it results in flashing on the locking tabs that will have to be trimmed off in order for them to fit together with the two halves flush with each other.
As you can see in the attached photos, the trim rings will interfere with the locking clips for the tonneau cover. They can of course be cut or ground to make clearance, but if you're going to do this, print using 100% infill or you'll quickly expose the rings' hollow cores.
Gravity alone will keep these more or less in place but applying double-sided tape or the hook part of stick-on Velcro ("hook and loop") is suggested for proper retention.
Happy printing! -SM