1 / 2
Herman Millen Aeron Vaz 2110 Headrest — zdjęcie 1
1 / 2

Herman Millen Aeron Vaz 2110 Headrest

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Headrest for a chair made using car headrest

Ocena
0 / 5
Polubienia
3
Pobrania
3
Wydruki
0
Wyświetlenia
80
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial

This is the first model I've created, and it started as a joke between friends: "What if you put a headrest from an old car on your fancy office chair?" For the clamp basis, I used the model https://www.printables.com/model/406660-herman-miller-aeron-headrest, which helped me a lot. The headrest mount was made with the help of Claude (but still needed some cleanup after that, for which I used Tinkercad). Expect big stress on the parts — car headrests aren't lightweight.

The car headrest rods (specifically from a VAZ 2110 rear seat) have the following dimensions:

  • Rod diameter: 12 mm

  • Center-to-center distance between rods: 125 mm

Print settings

I've used Creality PLA plastic for all parts, with 50% infill for structural integrity. Printed on Creality Ender 3 V3 SE printer.

Bill of additional materials

  • Car headrest :)

  • 1x M3x30 bolt

  • 2x M3x20 bolt

  • 2x M4x30 bolt

  • 2x M4x20 bolt

  • 5x M3 nut

  • 4x M4 nut

Build instructions

  • Install M3x30 bolt and M3 nut in the mainjaw part.

  • Install M3x20 bolt in the mainjaw part (it will be used as a brace for another screw and will help distribute force along the part).

  • Install the mount on the maingrip part using M4x30 bolts and nuts.

  • Put the headrest into the mount and fix it (but not too tight) with M4x20 bolts and nuts.

  • Insert M3 nut and M3x20 bolt in the bottom of the maingrip.

  • Insert the mainjaw into the maingrip, put it on the chair, and tighten the setscrew on the bottom of the maingrip.

  • Calibrate the new headrest for your sitting position and tighten all screws.

Considerations

The pivot connection between the "mount" and "maingrip" models relies on strong friction between them. If your printer has large tolerances, it may cause the mount to pivot under its own (and the headrest's) weight, or fail to hold when your head is resting on it. If you're not entirely sure how good your printer's tolerances are, consider adding additional stop notches (not really hard to do in slicer).

Tagi