Herman Millen Aeron Vaz 2110 Headrest
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Headrest for a chair made using car headrest
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 3
- Makes
- 0
- Views
- 78
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial
This is the first model I've created, and it started as a joke between friends: "What if you put a headrest from an old car on your fancy office chair?" For the clamp basis, I used the model https://www.printables.com/model/406660-herman-miller-aeron-headrest, which helped me a lot. The headrest mount was made with the help of Claude (but still needed some cleanup after that, for which I used Tinkercad). Expect big stress on the parts — car headrests aren't lightweight.
The car headrest rods (specifically from a VAZ 2110 rear seat) have the following dimensions:
Rod diameter: 12 mm
Center-to-center distance between rods: 125 mm
Print settings
I've used Creality PLA plastic for all parts, with 50% infill for structural integrity. Printed on Creality Ender 3 V3 SE printer.
Bill of additional materials
Car headrest :)
1x M3x30 bolt
2x M3x20 bolt
2x M4x30 bolt
2x M4x20 bolt
5x M3 nut
4x M4 nut
Build instructions
Install M3x30 bolt and M3 nut in the mainjaw part.
Install M3x20 bolt in the mainjaw part (it will be used as a brace for another screw and will help distribute force along the part).
Install the mount on the maingrip part using M4x30 bolts and nuts.
Put the headrest into the mount and fix it (but not too tight) with M4x20 bolts and nuts.
Insert M3 nut and M3x20 bolt in the bottom of the maingrip.
Insert the mainjaw into the maingrip, put it on the chair, and tighten the setscrew on the bottom of the maingrip.
Calibrate the new headrest for your sitting position and tighten all screws.
Considerations
The pivot connection between the "mount" and "maingrip" models relies on strong friction between them. If your printer has large tolerances, it may cause the mount to pivot under its own (and the headrest's) weight, or fail to hold when your head is resting on it. If you're not entirely sure how good your printer's tolerances are, consider adding additional stop notches (not really hard to do in slicer).