1 / 5
Lenovo M720q/M920q/M920x M.2 A+E 2.5GbE — zdjęcie 1
1 / 5

Lenovo M720q/M920q/M920x M.2 A+E 2.5GbE

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bracket to install M.2 A+E 2.5GbE NIC to Lenovo M720q/M920q/M920x

Ocena
0 / 5
Polubienia
10
Pobrania
76
Wydruki
1
Wyświetlenia
524
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

2.5GbE M.2 A+E Key NIC Bracket for Lenovo Tiny M720q / M920q / M920x

A simple mounting bracket that lets you add a 2.5GbE network card to your Lenovo Tiny (M720q, M920q, M920x series) using the M.2 A+E key slot normally occupied by the Wi-Fi module.

These little machines are hugely popular as home servers, firewalls, and Proxmox nodes, but they only come with a single 1GbE port. M.2 A+E key 2.5GbE adapters (typically Realtek RTL8125B-based) are a cheap and easy upgrade — the problem is that there's no clean way to route and secure the RJ45 daughterboard inside the chassis. This bracket solves that.

Features

  • Holds the RJ45 port module securely in place — no zip ties, no tape, no rattling

  • Does not conflict with the 2.5" drive bay — you keep your SATA SSD/HDD alongside the new NIC

  • ⚠ Occupies the rear PCIe bracket opening — the PCIe slot itself remains electrically free, but installing a PCIe card alongside depends on the card's length and form factor; standard bracket-mounted cards won't fit

  • Designed specifically for the M720q / M920q / M920x Tiny chassis (but may fit similar cases)

  • Quick to print, no supports needed

Printing

  • Material: PETG or ABS/ASA recommended (it lives inside a warm PC case, PLA may deform over time)

  • Layer height: 0.2 mm

  • Infill: 100% rectilinear — forces the slicer to properly fill the thin/critical areas instead of skipping them

  • Perimeter generator: Arachne (for clean thin walls)

  • Supports: none

Hardware needed

  • M.2 A+E key 2.5GbE NIC (RTL8125B-based, with RJ45 daughterboard on a cable) — this is the module I used; listings from other sellers appear to be identical clones and should fit as well

  • 2× M2.5×8 flathead screws (to mount the RJ45 port module to the bracket)

  • Original Lenovo chassis screws to mount the bracket to the case — or M3×6–M3×8 flathead screws if you don't have the originals

Bring 2.5GbE to your Tiny nodes without giving up the 2.5" drive bay.

Tagi