Potion of Holding — Twist-Lock Flask Organizer (2 sizes)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fantasy potion flask that twist-locks apart into a wide-mouth bin with a 4-way divider — four sorted compartments for
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 35
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Potion of Holding — a fantasy potion flask that is secretly a small-parts organizer. Twist the flask apart at its raised equator band and it splits into a wide-mouth bin with a 4-way cross divider (four sorted compartments) and a domed lid. A tapered cork plugs the neck so nothing rattles out. No hardware, no glue, no supports.
TWO SIZES from the same design:
Full size, about 56 x 88 mm — a desk organizer for screws, bolts, washers, beads, SD cards, dice, or any small hardware.
Mini, about 35 x 55 mm — scaled to close inside a 2.7 inch (68.6 mm) gacha capsule with room to spare. A capsule surprise or tiny trinket vial.
How it works:
Base carries a thick spigot with 3 bayonet lugs.
Lid drops over it, quarter-turn to lock (about 26 degrees).
Cork is a light friction fit in the neck, firm push, pulls out by the flange.
Printing (no supports):
Base on its flat foot. Lid mouth-down on its widest rim, add a brim so the thin rim does not lift. Cork flange-down.
0.2 mm layers. PLA is fine, PETG for a tougher lid.
Photos show the full-size print. The mini is the same geometry scaled to 0.62, with the twist-lock slack and cork gap held at the same real-mm values so both sizes fit the same way.
