OP-1 Case/Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A dual purpose protective case/stand for Teenage Engineering's OP-1
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 40
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Share Alike
I've made a couple of these over the years and they work very well. The case is reversable and has spots for rubber feet so it can be used as a stand by reversing the OP-1 inside it. As a case, it has room for some cables, earbuds etc. As a stand it frames the OP-1 nicely and at a comfortable angle.
Can be printed in one shot on a MK4S (my first was printed on MK3) without supports.
Likely does not fit the OP-1 Field as I don't have one of those. (If you wanna send me one, I wont say no). Fits snugly at first on the original OP-1, but after a few times in and out of the case it works really smoothly. I printed in PLA (Overture Silk Tiger Eye in this case) default 0.2 layer, structural with 15% infill.