1 / 3
Gen1 Nissan Xterra / Frontier – Power Steering Reservoir Relocate (2" Body Lift) — zdjęcie 1
1 / 3

Gen1 Nissan Xterra / Frontier – Power Steering Reservoir Relocate (2" Body Lift)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Gen1 Nissan Xterra / Frontier – Power Steering Reservoir Relocate (2" Body Lift)

Ocena
0 / 5
Polubienia
2
Pobrania
3
Wydruki
0
Wyświetlenia
40
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Open Community License v1.1 + General Attribution v1

I installed a 2-inch body lift  from 4x4Parts on my 1st gen Xterra, which left the power steering reservoir no longer able to reach the factory bracket. The common fix is to zip tie it to the bracket. But I didn't really like that solution as it doesn't secure the reservoir and allows for more movement than I would like.

This relocation bracket fills the gap between the factory bracket and the reservoir, and keeps the reservoir in the orientation it's intended to be in. 

Print Instructions:

  • Material: ASA or ABS. Do NOT use PLA or PETG for permanent installation. Under-hood temperatures will soften and deform the bracket.

  • Layer height: 0.2mm

  • Perimeters: 5 (~2mm wall)

  • Top/bottom layers: 6

  • Infill: 33%, gyroid

  • Post-processing: This might be overkill but I decided to paint it with Rust-Oleum Engine Enamel. I don't think it will do much to add any heat resistance but I'm hoping it will add some chemical resistance so it doesn't degrade if I get power steering fluid on it filling the reservoir. 

Tagi