1 / 4
Squarebody truck/GM car Window and Lock switch wiring terminals — zdjęcie 1
1 / 4

Squarebody truck/GM car Window and Lock switch wiring terminals

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These models can be printed to replace the factory door switch wiring connectors.

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
40
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution

I printed these out of ASA GF to replace the ones in my 83 K20. I haven't had any problems with the summer heat softening the plastic. I DO NOT recommend trusting these made out of anything with a low melting point. If you do, ensure you have a proper fused circuit providing power to the doors and keep your fingers crossed that nothing shorts to ground.

They use Auveco #23167 pin grip terminals; I purchased mine on amazon. These terminals only go up to 14-gauge wire, if you can find some bigger sizes let me know. I remade my entire power harness for both doors, so it wasn't an issue with the larger factory wires. I did not try to see if the factory terminals would fit, I do know they are slightly different than the Auveco's.

I went overkill on clamping the cover to the base after dealing with my faulty factory connectors coming apart so many times. They use #2 x 1/4" long screws to hold them together. I settled on some nice brass screws that I purchased at Lowes. If the metric system is more your flavor power to you, let me know what size works and I will update the description.

didn't grab a pic of the installed prints when I had my door panels off unfortunately. Wish I would've. I hope these help a few people out. If you end up using them, post some pics. Thanks!

Tagi