1 / 8
Transmitter tray console for Spektrum DX6, DX7, DX8 RC remote control — zdjęcie 1
1 / 8

Transmitter tray console for Spektrum DX6, DX7, DX8 RC remote control

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Transmitter tray console for Spektrum DX6, DX7, DX8 RC remote control

Ocena
5 / 5
Polubienia
4
Pobrania
63
Wydruki
1
Wyświetlenia
230
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a tray console for Spektrum RC Transmitter DX6, DX7, DX8.
Transmitter gets fully fixed and can't fall out. 
The transmitter console can be placed either flat or upright without the transmitter touching the ground.

Parts 1 & 2 are availabe in two versions regarding printer size.
If you have a bigger printer, you can use the "Full" files.
If you have a standard printer, you can use the "Half" files. Here some extra M4 screws are needed.

Part 5 (bracket) is now available in 3 sizes to adjust the tilt angle and optimize the transmitter's center of gravity when worn.
After several tests, I recommend version 5.2 for general use.

At the point where the transmitter rests against the bottom, the top cover has an overhang designed for attaching a foam strip to protect your transmitter.

Use ASA for UV and better heat resistance; otherwise, PETG will also work.
Use 3 or 4 walls and 30-40% Infill (Gyroid or Hexagon)

Needed:
16x M4 screws, 16-25mm (for fing parts 4)
4x M4 screws, 16mm (for parts 5)
4x M3 screws, 16 or 18mm (for part 3)
1x camera lanyard


Tagi