Umarex Notos (OEM) Rear Stock Wall Mount / Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ambi wall mount; custom-sized for the Umarex Notos OEM rear stock profile, buffer tube style.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a buffer tube style wall (closet door) mount for my Umarex Notos, but standard AR mounts don't work smoothly because the Notos OEM stock has a ridge that gets in the way/isn't perfectly round.
This is inspired by Joulez's AR wall mount (https://www.printables.com/model/1151840-ar-buffer-tube-wall-mount), but designed specifically for the Notos. I widened the opening to accommodate the stock ridge and tried to use a bit less plastic/speed up prints. It ended up being a good enough fit on the first print though.
It mounts using two #10 wood screws (5mm holes, could probably get away with #8/9 if there's enough bite) and keeps the rifle parallel to the wall or door. The rifle doesn't hang perfectly straight, but the design strikes a nice balance between holding the gun securely and being easy to lift in and out, and gives enough room for a scope (UTG bugbuster in my case).
My print settings, increase the infill and or perimeters if you're feeling insecure:
Polymaker clear PETG
4 perimeters
20% gyroid infill
My uncalibrated hand tells me it could hold quite a bit more than the notos weighs, but I'll update if it fails with these settings.
Hope this helps someone else get their rifle up off the box on the floor.
