1 / 4
Camper Dry Toilet Odor Ventilation – 60 mm Hose and 12 V Fan Mount — zdjęcie 1
1 / 4

Camper Dry Toilet Odor Ventilation – 60 mm Hose and 12 V Fan Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple 12 V odor ventilation for camper dry toilets. Uses a 60 mm hose and a fan with 50 × 50 mm hole spacing.No smell:)

Ocena
0 / 5
Polubienia
2
Pobrania
2
Wydruki
0
Wyświetlenia
49
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a simple ventilation system for a dry separating toilet in a camper, van or motorhome.

The complete setup requires three printed parts:

  • One part is attached to the toilet. (or use a outlet for 60mm heating system)

  • Two identical parts are used to clamp a 12 V fan between them. (with screws and nuts)

The fan mounting-hole spacing is 50 × 50 mm. The ventilation connection is designed for a 60 mm diameter hose.

For the hose, I used a flexible extraction hose normally sold for woodworking machines and dust extraction systems. The hose can be routed through the floor underneath the vehicle or through a side wall.

The fan can be connected directly to the camper’s 12 V electrical system using a simple switch. I connected mine through an inexpensive 3–12 V PWM speed controller, which allows the fan speed, airflow and noise level to be adjusted.

On the outside of the vehicle, I recommend adding a ventilation grille or weather cover to prevent insects, water, dirt and larger debris from entering the hose. A suitable standard exterior ventilation cover can be found in most hardware stores.

Since installing this system, there has been practically no smell while using the toilet. It works extremely well and has made the dry toilet much more comfortable to use inside the camper.

Required Parts

  • 3 printed parts

  • 12 V fan with 50 × 50 mm mounting-hole spacing

  • 60 mm ventilation hose

  • Switch or 3–12 V PWM speed controller (i installed both)

  • Electrical cable

  • Exterior ventilation grille or weather cover

  • Suitable screws and mounting hardware

Tagi