1 / 3
Lian Li A3 Bottom Cable Cover / Fan Shroud — zdjęcie 1
1 / 3

Lian Li A3 Bottom Cable Cover / Fan Shroud

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cable cover for the Lian Li A3 that hides cables while maintaining airflow through the bottom-mounted fans.

Ocena
0 / 5
Polubienia
4
Pobrania
23
Wydruki
0
Wyświetlenia
282
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Lian Li A3 Bottom Fan & Cable Cover

This cover is designed to fit at the bottom of the Lian Li A3 mATX case, sitting above the bottom-mounted fans. Its main purpose is to hide the majority of visible cables while still maintaining good airflow through the case.

Cable management in the Lian Li A3 can be challenging due to its compact size, especially when using a non-modular PSU. I designed this cover to tidy up the bottom of the case and hide excess PSU and other cables from view.

The cover is designed around 2 × 120 mm bottom-mounted fans and includes several cable cut-outs:

  • Small cut-out for a Wi-Fi/Bluetooth card

  • Large cut-out for PSU cables

  • Additional smaller cut-out for other cables

The honeycomb design allows plenty of airflow and does not significantly obstruct the bottom fans.

Versions

Version 1

This is the original version that I have personally printed and tested.

It includes larger openings above the two 120 mm fans, as well as mounting holes that allow the cover to be secured directly to the fans using spare fan screws.

Version 2

Version 2 features two filleted corners around the main cable openings for a slightly smoother and cleaner appearance.

The dedicated fan openings have been removed, as the honeycomb design already provides plenty of airflow. The mounting screw holes have also been removed, allowing greater flexibility with different fan positions and layouts.

Version 3

Version 3 is the same as Version 2 but retains the mounting screw holes.

Print Settings

  • 0 top shell layers

  • 0 bottom shell layers

  • Honeycomb infill

  • 15% infill

  • 2 wall loops

  • Split the model in your slicer to fit your printer's build plate

Important: Make sure both the top and bottom shell layers are set to 0. Otherwise, the slicer will generate a solid surface over the honeycomb infill, which will block airflow.

Wall loops are also required to create the outer edges, cable cut-outs and screw holes. Without them, you will be left with only the honeycomb infill pattern.

These are the settings that worked well for me, but feel free to experiment with the infill percentage, wall count and other settings to achieve the finish you prefer.

I printed mine in PLA and have experienced no issues with heat or warping.

Tagi