USS Spool Adapter collection
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Collection of spool adapters to fit different spools into the USS drybox with minimal unspooling friction.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 1
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Had extruder issues after a setup change to USS dryboxes, because non Prusament-spools, especially paper spools, were to hard to pull out of the box, causing several problems like the PFTE tube getting pulled into the box or the extruder gear loosing grip, resulting in print failures.
Printed several adapters which fit their spools just fine and improved unspooling out of the drybox while it layed on its side, but still got friction issues standing upright.
So I started to design adapters which ID (⌀51mm) fit the drybox, OD of the spool hole, the collar width covers the boxes gliding rings and thickness adapts the spool to Prusament spool width (68mm).
Started with an older ⌀73mm Sunlu spool (also fit Jayo) and ⌀55,5mm Eryone paper. Will add more in future.
If you need other diameters, just send me a PM with spool hole diameter and spool width (depth of the spool hole). Just until I figure out the parameterised stuff on here.
Printed with HF0.4mm, 1 Perimeter, 10% Gyroid.