SSV (Sammy Seta Visco) Rotary Switch Case and Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount and Case for the SSV Seta Rotary Switch MOD for the SSV arcade PCB.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
A friend of mine made the rotary switch mod for the SSV (Sammy Seta Visco) 4-in-1 multi, so I decided to make the mount and shell for it so it has a home and makes switching games a breeze.
You'll need a few things to make this.
BOM:
- 2 x M3x14mm screws (for mount to PCB)
- 2 x M3 washers
- 2 x M3 locknut (preferred so mount can't get dislodged from PCB)
- 2 x M3x6mm screws (mounts bottom shell to mount itself)
- 2 x M3x3x4.5mm threaded inserts. 4.5mm is the diameter spec.
Installation:
1) use the m3x14 screws to secure the Mount to the PCB using the M3 washers and M3 locknut.
2) since the mount is secured, it'll be easy to install the m3 inserts now, so proceed with that; don't go too far or you'll just go through the mount altogether.
3) Secure bottom shell to the mount using the M3x6mm screws
4) Put the rotary PCB into the top shell first, then snap it into bottom shell; hold the bottom shell so you don't apply too much vertical pressure as it could break the mount.
NOTE: You're more than welcome to mount the Bottom and Top shells first to the mount before installing on the PCB if that's easier for you.
Helper PCB: This is to support the small PCB that goes on the 4-in-1 board. It helps prevent any potential shorts; just put this between help PCB and 4-in-1 PCB prior to soldering. You can see it in the picture how it is installed.
Printing: Use supports to print this. Uncheck the "Remove small overhangs" in Bambu slicer so that it supports the larger overhang. May or may not be in other slicers.