Arrma Typhon Grom Skid Plates
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Skid Plates for the Typhon Grom to protect the chassis and screws.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 143
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
We have been racing our Typhon Groms in parking lots and the screws have been talking a beating! If you have ever tried to remove a screw from the bottom of a chassis that has been ground down, you know what I'm trying to avoid.
I tried the metal skids from Amazon, but the screw locations were off and the screws were still taking a lot of wear.
I designed these skids to have extra depth to protect the screws. Since they are printed with about 20 cents of material, I plan on replacing them often.
The front skid location does have a slight bend, so I suggest putting the two screws in the front, heating the skid plate with a heat gun or torch, then gently bending it back to put the two rear screws in.
I suggest at least 6 walls and 100% infill for strength. They are small parts and should be around 9g in filament.