Double Lens Adapter for Headband Magnifier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement lens holder that allows two lens assemblies to be installed simultaneously for increased magnification.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This adapter replaces the original single-lens holder on the headband magnifier shown in the photos.
It provides two parallel slots, allowing two lens assemblies to be installed and used simultaneously for increased magnification.
The exact magnification and focusing distance depend on the combination of lenses being used. Higher magnification will generally result in a shorter working distance and a narrower field of view.
The adapter installs in place of the original holder and uses the original mounting position. After installation, slide one lens assembly into each slot.
Compatibility
This part was designed specifically for the headband magnifier shown in the photos.
Other visually similar magnifiers may use different mounting dimensions, so compatibility with other models is not guaranteed.
Printing notes
Material: PETG
Layer height: 0.2 mm
Perimeters: 3
Infill: 15–20% should be sufficient
Supports: required; organic supports are recommended
Print orientation: use the orientation shown in the slicer image
After printing, carefully remove the supports from the lens slots and lightly deburr the slot entrances if necessary. Check that both lens assemblies slide in freely before installing the adapter on the magnifier.
If this helped you, you can buy me a coffee:
Or use my referral @MaxPi when purchasing a Prusa printer — you will get Prusameters, and I will receive some too.