Scosche MagicMount MAGVM2 Vent 17mm Ball Adapted
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Scosche MagicMount rear faceplate adapted to use standard 17mm ball joint rather than the proprietary 15mm ball joint
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 38
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
For the Scosche MagicMount Vent MAGVM2 / SCMAGVM2I rear faceplate with 17mm threaded ball joint to use with generic phone holder mounts rather than the proprietary 15mm joint. Includes a blank plate to adapt your own needs.
You'll unscrew the 4 screws on the rear of the mount and pop off the plastic rear faceplate and swap with this model. Assemble with the same screws snug but not overtly tight.
Best printed with PETG for the summer heat. Thread section should be printed at maximum 0.15mm layer height. Whichever layer height you choose for the threaded area, match it with the nut locking ring.