ESP32 Louder Mini x IKEA Kallsup 20$ Multiroom Speaker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Build a $20 multiroom speaker using the ESP32 Louder Mini and an IKEA Kallsup speaker.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 511
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
This is a shim to install an ESP32 Louder Mini board in an IKEA Kallsup speaker housing. It fits right in and the speaker looks the same as before, just with Snapcast (or whatever you flash to it) support.
This can be used to build a very nice, very slick looking $20 multiroom speaker that can be controlled from your Snapcast server (like Music Assistant @ Home Assistant).
What you need:
An ESP32 Louder Mini Board (those will be restocked occasionally)
https://www.tindie.com/products/sonocotta/louder-esp32-mini/An IKEA Kallsup speaker
https://www.ikea.com/de/de/p/kallsup-bluetooth-r-lautsprecher-tragbar-weiss-60594159/4 brass inserts and matching M3 screws. The inserts need to fit in a 4mm hole on the shim.
How to do it:
Open the speaker using the two screws at the bottom.
Remove the original board (it is just slide in, you can remove it by pulling it out, no screws).
Remove the battery (the ESP32 Louder Mini does not support battery power).
Unplug the speaker from the old board and cut off the plug on the speaker.
You might want to solder a wire extension to the speaker, otherwise it will be difficult to fit everything together. You can remove the speaker using 3 screws.
Connect the speaker wires to the ESP board.
Remove the battery posts with a plier. Make sure to cut them as flush as possible with the back plate.
Mount the board to the shim using the brass inserts and 4 screws.
Remove the rubber protection from the original boards USB plug, cut the back part of the rubber off to it fits on the new board's USB port.
Use hot glue to fix the shim (AND the board) to the back cover, fitting the USB hole in the cover. Do this with the board screwed into the shim to get the alignment right.
Fit everything back together, done.
Important: the reset and program buttons are on the outside facing side of the board, so they can't be accessed without unscrewing the board from the shim. Make sure you have flashed the firmware you want to the board before screwing it into the shim. The board will need to special reset button sequence for the web flash to be working. Refer to the documentation on the ESP Louder Mini page above for details.
To save you a lot of trying around, using the Sendspin protocol worked best for me. I had audio stuttering with Snapcast, but Sendspin worked without issue on same hardware and network. Make sure to have a good power supply, the loudness of the audio depends on what the power supply can provide. So if you have one speaker that is noticeably lower volume, check the power supply.
