1 / 4
3-Inch Toothpick Drone Frame v8 — Sub-250 g, GEPRC Taker G4 + RP3 Covers — zdjęcie 1
1 / 4

3-Inch Toothpick Drone Frame v8 — Sub-250 g, GEPRC Taker G4 + RP3 Covers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3-inch toothpick drone frame v8 with GEPRC Taker G4 and RP3 covers. 164 g build, prints in PETG with no supports.

Ocena
0 / 5
Polubienia
2
Pobrania
23
Wydruki
0
Wyświetlenia
147
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

What it is

The printed airframe from Phase 1 of Project Cheap Drone: a 3-inch toothpick quad that weighs 164 g all-up. That is under 250 g, so it does not need FAA registration. Flown line of sight.

In this download

  • Frame v8: body, arms, legs and mounts

  • Flight controller cover: fits the GEPRC Taker G4 AIO

  • Receiver cover: fits the RadioMaster RP3 ELRS Nano

Print settings

PETG · 0.25 mm layers · 50% infill · 3 perimeters · no supports. ASA was too flexible and the legs snapped.

Built around

  • Flight controller + ESC: GEPRC Taker G4 45A AIO, 25.5 mm M2, on rubber grommets (exact board on GetFPV)

  • Motors: iFlight XING2 1404 3800KV

  • Props: Gemfan Hurricane 3016 (3-inch = prop size)

  • Battery: OVONIC 4S 650 mAh, XT30

  • Receiver: RadioMaster RP3 ELRS Nano (2.4 GHz)

Screws

  • Motors: M2 × 6 mm. Not M2 × 8: a longer screw can hit the motor windings and short it.

  • Props: M2 × 8 mm.

Heads up

  • Cable routing works but is not tidy. v9 will fix it.

  • The legs are springy on purpose. The first rigid set snapped.

  • Check your prop arcs before the first spin-up.

  • First power-up: use a smoke stopper, and charge LiPos in a fireproof bag or box.

Parts I modeled for this build

Parts list

Amazon links are affiliate links.

Watch the build

Credits

Motor and receiver models by Riley Entropy: XING2 1404 · RP3 ELRS RX. Please like their work.

Modeled in

Shapr3D (affiliate)

License

CC BY 4.0. Use it, remix it, share it, sell it. Just credit @shreyashgupta.

Changelog

v8 (August 2026): battery on top, electronics underneath, capacitor channel, springy legs.

Disclosure

I am a Shapr3D Creator Partner and an Amazon Associate. I earn from qualifying purchases at no extra cost to you.

Tagi