1 / 10
Raspberry Pi Articulating Camera Mount w/ No Glue, Clips Into the Unused DSI Slot — zdjęcie 1
1 / 10

Raspberry Pi Articulating Camera Mount w/ No Glue, Clips Into the Unused DSI Slot

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Supports Miuzei Raspberry Pi 3/4 cases, and supports Arducam 16MP IMX519 and Dorhea 5MP OV5647 cameras.

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
21
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

These models are made to slide into the unused DSI port of your Miuzei Raspberry Pi cases, there are Pi3/4 cases are far as I know on Amazon. The stem has a ball-joint mechanism, allowing full articulation. Tilts 90 degrees through a drop notch, allowing you to point straight up. Tilts up to 48 degree. Pan is 360 degrees.

Required equipment:

  • raspberry pi 3/4

  • 8 M2.5 screws x 8mm (can also use 6mm and 12mm)

  • 1 M3 x 12mm screw and nut to tighten the ball-joint mechanism

  • 3D printer (I use Elegoo Neptune 3 Pro)

  • Camera: Arducam 16MP IMX519 or Dorhea 5MP OV5647 w/ IR sensor

  • screwdriver

You don't need every model file. Pick the file type that you prefer and only download those.

Tagi