1 / 2
Segway Navimow X4 RTK GNSS (GPS) antenna mounting bracket (for vertical surface) — zdjęcie 1
1 / 2

Segway Navimow X4 RTK GNSS (GPS) antenna mounting bracket (for vertical surface)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Baseplate to mount Segway Navimow X4 RTK GNSS (GPS) antenna pole to a vertical surface (at 0º or 3.5º tilt)

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
83
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
BSD License

This is a pair of models to mount the Segway Navimow X4 (X430, X450) "EFLS" (RTK GNSS/GPS) antenna base station pole/mast to a vertical surface (with second design for a surface with a 3.5º outward tilt).

Two mounts:

  • Lower mount: Has a hard stop at the bottom for the bottom of the pole

  • Upper mount: Has a through bore the diameter of the pole, for additional stabilizing attachment farther up the pole.

The mounts offset the pole center 4.65in (118mm) from the surface to which it is attached (and, as expected, a bit more for the 3.5º version).

A machine bolt/screw is used affix the pole section to the lower mounting plate: an M12x1.25mm ("extra fine pitch" threads)x≥30mm length. The bolt screws into a threaded plug welded into the post from the factory, that is normally used attach the pole to the OEM ground spike.

The mounts are intended to mount to a surface using #8 screws (M4 should also work).

Print orientation:

  • Print the mounts with the bottom plane flat on the print bed, in the same orientation they would be used. Supports needed for the lower mount below the hard stop in the center bore.

Suggested filament type:

  • PETG or ASA, ideally with carbon fiber or glass fiber reinforcement. TPU-CF could be another good choice if you have it.

Suggested print settings: 

  • 0.3mm layer height

  • 20–40% infill

  • Seam placed along inner screw hole and surface

  • Vertical shells: 4

  • Top/bottom layers: 4

  • Scarf joint placement: everywhere

  • "Mouse ears" or brim suggested to help keep the mount from curling off the print bed

Supports:

  • Supports to support plane below center bore (lower mount only).

Note: This is specific to the Segway Navimow X4 series of robotic lawnmowers, and possibly also specific to models of such mowers sold in the United States. Antenna dimensions for other Navimow mowers may differ, based on anecdotal reports online.

Tagi