550cc syringe vacuum.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Creates a vacuum inside a 550cc syringe. Good for mixing small batches of silicone.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
There are two ways you can make a lower pressure environment. You can either keep the chamber the same size and remove the air inside (expensive), Or you can take a chamber, and expand it without letting any air inside to fill the chamber.
This was the most inexpensive way that I could think of to get my business of creating silicone based wrist rests off the ground with the very little money I had. Someone gave me the idea and I thought it was a joke but they were thankfully persistent. This will fit over a 550cc syringe that you can get from amazon and you can use the lead screw from your old and rotting ender 3 for the mechanism with an old hex key wrench or whatever you can find to give yourself leverage.
Make sure to print the plunger on its side and the plunger puller needs to be printed standing up so you take advantage of the layer lines within your printer. if you don't have a large enough printer for these, I'm sorry but I don't have a great way at this time to make it smaller without introducing weaknesses.