Modular Benchy Spool Carousel Display Hobby Lobby Edition
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix to allow use of Hobby Lobby filament spools for an expandable Benchy display.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 49
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial
The original model's two-piece display ring is too small for the internal diameter of the Hobby Lobby filament spool. The other parts fit fine. I have a plethora of empty Hobby Lobby filament spools and print a Benchy every time I get a filament I have not used before. I decided to go further to allow me to stack multiple spools and expand the Benchy display. To do this, I increased the bottom display rings to fit the larger spool diameter. I changed the rod to a shaft that fits inside the spool for stability and added the same thread pattern on top and bottom. I also made some holes and a simple “wrench” so you can attach the shafts more easily. The ring was rethreaded so all thread patterns are the same. The original base, top, and knob went unmodified. The entire display or the individual spools can be rotated. Each display ring can hold 11 standard Benchies.
To assemble, you will need a 608 bearing and adhesive for the two-piece bottom display pieces. Adhere the bottom display to the inside of the spool flange. Do not glue the top display piece to the flange unless it is the very top spool. The shaft will hold the top display in place without adhesive. Install the bearing into the ring opening. The bearing will face downward. Slide the shaft through the spool and screw it into the ring. To add a spool, print another shaft, slide it through another spool, and screw it into the shaft. (NOTE: Unless you secure the Benchies to the display, you will have to remove them to add spools. Use Superglue or epoxy to permanently secure the Benchies to the display.) If the spool is the top spool, place the top display ring onto the outside flange before sliding the shaft through. Slide the bearing onto the base post and attach the knob to the top shaft to allow you to turn the display. Alternatively, you can turn the individual spools. Let's see ho can make the tallest display!
Thank you, StrandedOrg for the original model!
