1 / 9
X-Shot Break Barrel/Spinshot Picatinny Stock Point — zdjęcie 1
1 / 9

X-Shot Break Barrel/Spinshot Picatinny Stock Point

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a picatinny stock point made to fit the X-Shot Break Barrel/Spinshot

Ocena
5 / 5
Polubienia
22
Pobrania
47
Wydruki
1
Wyświetlenia
304
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Hello Everyone!

This is a picatinny stock point made for the X-Shot Break Barrel/Spinshot.  After getting my hands on this blaster and seeing that the area in the shell for the hammer looked like it was larger than it needed to be, I thought I might be able to use that area as a place to anchor a stock point to the back of the shell. It seemed like a fun challenge, so I decided to try and make it, and here are the results! 

Printing Information

My primary goal for this project was to make the parts in such a way that no alterations to the stock shell would be needed.  Additionally, I tried to keep the parts as easy to print and assemble as possible while also keeping the hardware as minimal as possible. In the end, the kit is comprised of four printed parts and requires the following hardware:

  • 2 M3 x 10mm screws

While all parts require support material, all support material should be in places where they are easy to remove. I recommend the print orientations shown below for each part:

Kit Assembly

The pieces are intentionally a tight fit so that the stock point is held securely to the shell, so the screws will need to be tightened for it to fit correctly onto the shell.  The shell does need to be opened up for the hammer to be replaced, and while this mod does not require adjustments to any of the other internals apart from the hammer, there is a chance that some of the small sprung parts of the mechanism could come out of place, so caution is encouraged. If any of the parts do come out of place, the prodigious Bruce LeedleLeedleLeedleLee has uploaded a video of how to reassemble this blaster, which I will link HERE. 

Sendoff

I had tons of fun working on this project, and I hope everyone else enjoys it as much as I have! 

Thanks to Kats_Creatives for testing these files and providing feedback! They do very high quality work, and I'm very excited for the parts they are developing for the Spinshot/Break Barrel. I highly recommend checking out their work, which can be found on their Printables page as well as their Linktree. 

Tagi