Standard Creality K2 Two-Plate Desktop Holder - One Piece

Description

This freestanding holder stores two flexible spring-steel build plates for the standard Creality K2 (non-Pro, non-Plus).

The design uses two diagonally opposed slotted towers connected by a thin butterfly-shaped base. Supporting each plate at two separated points keeps the model compact while permanently aligning the slots. It prints as one connected part with no assembly or hardware.

Compatibility

- Standard Creality K2 only

- K2 printable area: 260 × 260 mm

- Intended plate size: 270 × 293 mm

- Capacity: two plates

- Not sized for the K2 Pro or K2 Plus

Model dimensions

- 240.1 × 162.7 × 62 mm

- Two 3.2 mm slots in each tower

- Approximately 12.8 mm clear divider between the stored plates

- 5° rearward plate lean

Print settings

- Material: PETG preferred; PLA or PLA+ is suitable away from heat

- Layer height: 0.20 or 0.24 mm

- Walls: 4

- Top and bottom layers: 5

- Infill: 20% gyroid or cubic

- Supports: none

- Orientation: print exactly as supplied, broad base on the bed

- Bed adhesion: skirt recommended; avoid an unnecessarily wide brim

Use and fit check

Insert each clean, cool plate into the matching groove in both towers. Do not force a plate into a tight groove. If your coated plate is unusually thick, increase slot_width in the included OpenSCAD source and regenerate the STL.

The STL has been digitally checked as one connected watertight manifold. Physical print and long-term stability testing are still pending, so this release should be treated as a beta until confirmed on a real K2.