Standard Creality K2 Two-Plate Desktop Holder - One Piece
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Compact one-piece desktop rack for storing two standard Creality K2 build plates.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 2
- Makes
- 0
- Views
- 28
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
Description
This freestanding holder stores two flexible spring-steel build plates for the standard Creality K2 (non-Pro, non-Plus).
The design uses two diagonally opposed slotted towers connected by a thin butterfly-shaped base. Supporting each plate at two separated points keeps the model compact while permanently aligning the slots. It prints as one connected part with no assembly or hardware.
Compatibility
- Standard Creality K2 only
- K2 printable area: 260 × 260 mm
- Intended plate size: 270 × 293 mm
- Capacity: two plates
- Not sized for the K2 Pro or K2 Plus
Model dimensions
- 240.1 × 162.7 × 62 mm
- Two 3.2 mm slots in each tower
- Approximately 12.8 mm clear divider between the stored plates
- 5° rearward plate lean
Print settings
- Material: PETG preferred; PLA or PLA+ is suitable away from heat
- Layer height: 0.20 or 0.24 mm
- Walls: 4
- Top and bottom layers: 5
- Infill: 20% gyroid or cubic
- Supports: none
- Orientation: print exactly as supplied, broad base on the bed
- Bed adhesion: skirt recommended; avoid an unnecessarily wide brim
Use and fit check
Insert each clean, cool plate into the matching groove in both towers. Do not force a plate into a tight groove. If your coated plate is unusually thick, increase slot_width in the included OpenSCAD source and regenerate the STL.
The STL has been digitally checked as one connected watertight manifold. Physical print and long-term stability testing are still pending, so this release should be treated as a beta until confirmed on a real K2.