1 / 3
Philips Sonicare HX6110 / HX3696 Dual Toothbrush Charger Holder — zdjęcie 1
1 / 3

Philips Sonicare HX6110 / HX3696 Dual Toothbrush Charger Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Desktop holder for 2x Philips Sonicare HX6110 / HX3696 Toothbrushes and Chargers

Ocena
0 / 5
Polubienia
3
Pobrania
7
Wydruki
0
Wyświetlenia
74
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bathroom
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a desktop/countertop holder for 2x Philips Sonicare HX6110 / HX3696 Toothbrushes and Chargers. There is a tiny bit of space inside to hide most of the unused cords. 

After printing, I recommend you clear coat it to avoid water/moisture absorption.

You can attach rubber bumper feet underneath afterwards to keep it from sliding around.

Print in PLA or PETG with 0.4mm nozzle. Rotate the model so it is front side down (i.e. the holes for the USB cables should point up). Use Snug or Organic supports.

To insert the chargers, first thread the USB connector from inside out the back. Any unused length of cord can be pushed into the space beside where the charger goes. Then carefully insert the charger (it is a snug fit!).

Tagi