Philips Sonicare HX6110 / HX3696 Dual Toothbrush Charger Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Desktop holder for 2x Philips Sonicare HX6110 / HX3696 Toothbrushes and Chargers
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 7
- Makes
- 0
- Views
- 74
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a desktop/countertop holder for 2x Philips Sonicare HX6110 / HX3696 Toothbrushes and Chargers. There is a tiny bit of space inside to hide most of the unused cords.
After printing, I recommend you clear coat it to avoid water/moisture absorption.
You can attach rubber bumper feet underneath afterwards to keep it from sliding around.
Print in PLA or PETG with 0.4mm nozzle. Rotate the model so it is front side down (i.e. the holes for the USB cables should point up). Use Snug or Organic supports.
To insert the chargers, first thread the USB connector from inside out the back. Any unused length of cord can be pushed into the space beside where the charger goes. Then carefully insert the charger (it is a snug fit!).