Rivian R2 rear driver cubby NACS adapter holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for your J1772 and CCS1 adapter in the Rivian R2 rear driver trunk cubby
- Ocena
- 5 / 5
- Polubienia
- 32
- Pobrania
- 428
- Wydruki
- 4
- Wyświetlenia
- 3320
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Just got a new Rivian R2, and I needed a place to store my Rivian shop provided J1772 to NACS and CCS1 to NACS adapters where they wouldn't rattle around and make noise. this fits in the trunk cubby behind the driver side, right below the power output options, and just inside by the charge inlet itself, so if you need an adapter, you just drop the glass, reach in and grab one.
Print in a high temperature safe filament (PETG, ASA, etc). I used PETG-CF, 4 walls, 15% gyroid infill, at .25mm layers. No supports needed. Sized to fit on a MK4S bed completely flat with the NACS plugs facing up.
One interesting thing I found in my prototyping was that the CCS1 and J1772 adapters had slightly differently sized NACS plugs, so the front one closer to the driver is just a bit bigger, and that's where the CCS1 adapter should go. J1772 fits at the back.
There may be room enough in this for the Field Outlet to fit as well, and if so, I'll upload another version once mine arrives.