Kayak Paddle holder TPU - for 3/16" rivets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Based on the 'Kayak Paddle holder - for 3/16" rivets', I loved the design, but wanted it in/for TPU
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Public Domain
The original really was good and I almost used it as is, but I really wanted to try it in TPU. Printed well enough, but with it being stretchy, I needed to make the clamping arms tighter. So I split the model in half, brought the two sides together and filled in the lower notch for strength.
Print settings:
TPU filament
10 wall loops with .4 nozzle
Grid in fill at 15%
One wall top surface
Avoid crossing walls (tpu stringing)
Clean with rubbing alcohol and used clear silicone to fill hole under and add additional "glue". I attached it with aluminum rivets. That boat is a two seater. On the first one I found popping the rivet was a little too tight and squashed the TPU more than I wanted. On the second I tighten the rivets close to popping but before it squashed the TPU, then cut the rivet with a dremel.