Revenant Series: Pendant
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A pendant shade with two woven skins, one inside the other, and a gap between them, prints with no supports (ASA recco)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 22
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Revenant Pendant Lampshade
This pendant lampshade features a unique double-layer woven design. When turned on, the overlapping pattern casts a soft, scattered light across the room rather than harsh lines or stripes.
How It Fits Together
The shade mounts onto any standard E27 light socket. The printed lid snaps securely into the top of the shade using four flexible clips that slot between the inner and outer layers. Once in place, the socket's threaded ring clamps the lid tight.
No screws, glue, or extra hardware are required!
3D Printing Tips
No supports needed: Both parts print cleanly as provided in the files.
Print upside-down: The shade is designed to print upside-down, standing on its wide top rim. Do not flip the file!
Lid orientation: Print the lid with the wide flange facing down onto the bed.
Bed adhesion: Use a brim for the shade to ensure proper bed adhesion, as the contact area is relatively thin.
Bulb Requirements
Important: Insert the bulb once the lid is on the socket - then just lower into the shroud and clip on lid.
Assembly Instructions
Attach the lid to the wired socket and screw in your holder
Screw in your lighbulb
bring the shroud over it through the top hole
press the lid firmly into the top of the shade until the four clips slide into the gap between the layers and click into place flat against the rim.
I print using ASA or PETG, since bulbs can get hot.