DJI OSMO Pocket 3 & 4 Screen Fix Frame (antitwist)

Anti-Twist Screen Lock for DJI Osmo Pocket 3 & 4 (pro and non pro)

Tired of your Pocket's screen twisting or flopping open on its own? This fixes it

If you own a Pocket 3 or Pocket 4, you already know the problem: in some cases the screen stops reliably staying locked in the horizontal position. It creeps, it twists, it flops open in your pocket, your bag, or your camera case and you find out the hard way when you pull it out and the screen's been exposed and knocked around the whole time.

This is a Pocket 3 and 4 common problem that results in the screen spring to stop working and screen gets stuck in middle position

This tiny clip solves the problem whether you already have it or want to .

What it does

• 🔒 Locks the screen flat: snap it on and the screen stays exactly where you put it, no more accidental twisting that can break the spring mechanism.

• 🛡 Protects the screen when not in use: keeps it from opening or getting scratched while it's rattling around in your pocket, bag, or case

• 🎒 Pocket-safe: no more worrying it'll flip open or rotate when you're not looking

Why you'll actually use this one

• ⚡ Prints fast: done in well under an hour

• 🧵 Barely any filament: this is a scrap-plate print, costs you next to nothing (less than 3gr)

How it works

Simple press-fit clip that locks the screen module in the horizontal position when shooting. Slide it on in vertical position before you toss the Pocket in your bag, slide it off when you're ready to shoot.

Print settings

• Material: PLA or PETG (better to use the last for durability)

• Layer height: 0.16 or lower for best quality on the interior lip

• Infill: 15–20%

• Supports: Not needed

• Print time: ~20–30 min

Small print, big peace of mind. Never find your Pocket screen flopped open again or keep it horizontal if the spring is already acting funny