X-Shot MPP Stock Picatinny Conversion Piece
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A piece that screws onto the collapsible stock from the X-Shot MPP that lets the stock be mounted to picatinny rails
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 18
- Wydruki
- 1
- Wyświetlenia
- 137
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hello Everyone!
This is a part that allows the stock from an X-Shot MPP to be used on a standard picatinny rail stock point. I decided to print out an alternate stock for my MPP, so the collapsible stock the blaster came with was just sitting around collecting dust. It's a good piece of hardware that I didn't want to go to waste, so I decided to make a part that could be screwed onto the end that would allow it to be attached to picatinny rails and thus used on other blasters besides the MPP. I saw that the very talented Donutcat had already created and shared a model of the threads for the MPP stock, which I knew would make this project even easier to complete. So, I got to work, and here are the results!
Printing Information
My primary goals for this project were to make the part fit the look of the rest of the stock as well as feel strong and secure when in use. Additionally, I tried to keep the part as easy to print as possible while also keeping the hardware as minimal as possible. In the end, the one printed part requires the following hardware:
2 M5 x 30mm bolts
2 M5 nuts
I recommend the print orientation shown below, which should allow the part to be printed without any supports:
Stock Assembly
Sendoff
I had tons of fun working on this project, and I hope everyone else enjoys it as much as I have!
Thanks to Donutcat for uploading their MPP stock thread samples, which made this project a breeze!