Quick-Clip Module for Garmin inReach Mini 3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I didn't find a module for the Quick-Clip system by Taylor that was adapted to the inReach Mini 3, so I made one.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This module, adapted for the Quick-Clip system by Taylor and inspired by a Strap Clip design by David Dirksen, was designed for use with the Garmin inReach Mini 3 device. It provides an easy way to secure the device to your bag while having it quickly accessible in case of emergency. If using one of the locking pins (highly recommended), pull the pin and pull the device out of the buckle to access.
I would recommend printing these in PETG (I did glow in the dark) or something heartier as this is holding your means of rescue while you're out and about.
You'll need:
M3x5x4 - Voron Threaded Heat Inserts - Qty x 2
M3x8 BHCS - Qty x 2
M3x8 FHCS - Qty x 1
Print settings I used:
20% Gyroid Infill
4 Walls,
5 Top/Bottom Layers
Supports Enabled for Positioning Tab
I also added some text to the back for contact info if found.
Note that the clip project file just uses some subtractive cylinders to create the M3 holes. Feel free to make your own. Inserts are 6.5mm center to center and at 45 degrees to the bottom edge of the clip.