SYS3-RAIL-IVAR (IKEA)

I had to store a lot of Systainers in a pretty small space and was looking for a cost effective solution. My storage room was partly filled with IVAR shelfs from IKEA witch I didn't want to throw away. 

It is an easy and cheap storage solution, witch is pretty common, and theirfore easy to sell if not needed anymore. If you need to buy it, then you only need the stands.

I also avoided to make any changes to the IVAR system itself, anything there is stock.

How I printed them:

• the rails are intended to be printed at 45° (no supports, higher strength)

• Settings: 0.6mm nozzle, 0.3mm layer hight, 4 outer walls, 20% cubic infill, "alternate_extra_walls" for better interlocking with the infill, 3 top/bottom layers, 70°C buildplate, PETG

• voron clone core xy 350x350mm at 45° rotation on the build plate

• It takes about 4h30' to print a pair of them.

mounting:

• As the original shelf-boards are not wide enough you need to make the shelf wider.
  There are many ways to do that. I decided to use some scrap wood and printed adapters. 
  "IVAR-SHELF_ADAPTER" and wooden boards 300x410x18mm.

• Hex screws M6x60mm (you can use 4 on each side, I found 2 on each side to be enough)

• There are screw holes in the rails which are intended be used in addition to the hex screws if you feel you need it.