Capcom Sony ZN-2 Case w/ Label Area
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for the ZN-2, remixed to have a spot to put some labels
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 19
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Based on Roberyguy09's ZN-2 case.
A case for Capcom Sony ZN-2 boards. It has some spots where you can place some labels.
The main label area for this one is 103x144mm, while the "serial label" spot is 65x40mm, based on CPS2 label sizes. The case's design is based on the Everten Stereo variant of Robertguy's case. There's a small spot above the stereo holes for a 12x40mm label. There are spots on the bottom of the case for 25mm circular rubber feet.
Requires:
4 - m3 x 5.7 threaded inserts
3 - m3 x ~16mm screws
1 - m3 x ~25mm screw
Optional (If using Everten Stereo PCB):
1 - 10mm x 6mm female-male brass standoff (Included with Stereo PCB)
1 extra m3x-16mm screw (To replace the 25mm screw)
There are some issues with this design to note:
Bottom right edge corner of the case top is not perfectly flush with the rest of the top side and it'll print weird if you don't fix it
CAPCOM indent doesn't print very well at high layer thickness
I haven't printed the volume knob yet (which is why it's not in the photos) but it should work. Robertguy's original volume knob should also be compatible.