Siemens LC85KDK60 Extractor Hood Magnet Cap Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement magnet cap for the Siemens LC85KDK60 extractor hood, with a push-out hole for easy magnet removal.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 6
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
Replacement magnet cap for the Siemens LC85KDK60 extractor hood.
This model replaces the small original cap that holds the magnet. The dimensions were refined through test prints and verified on the actual extractor hood. A central push-out hole makes the tightly fitted magnet easier to remove. It's a bit of a snug fit and requires some force so once its in it might be difficult to remove.
Dimensions:
12 mm magnet opening
15 mm main outside diameter
16 mm maximum ridge diameter
4 mm overall height
4 mm push-out hole
Printing:
Place the flat closed face on the build plate
Print with the opening facing upward
No supports required
0.2 mm layer height
0.5 mm outer-wall line width
PETG recommended for durability; PLA should also work
The fit has been physically tested on a Siemens LC85KDK60. It may fit related Siemens extractor hoods that use the same magnet cap, but compatibility with other models has not been verified.