Sprinter Dash Switch Trims (VS30 / W907)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Switch panel trim parts that match the curve of the OEM parts, and click-lock into the OEM panel.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 9
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
About
These switch panel blanks fit very well in a Mercedes Sprinter VS30 / W907 OEM panel, to add additional switches to your van with a clean look. Their key design value is the spring/locking mechanism which is similar to OEM Mercedes panel switches: they lock into the panel the same way.
I've used them to add controls for off-road lights, a compressor, and a LPAD dial to fix the sound problems from the center dash speaker.
Blanks are also included for the middle and edge positions in case you want to make a custom part. Modify the blanks with the cutout you need for whatever you are mounting.
Center Speaker L-PAD
The Sprinter center dashboard speaker is notoriously terrible for music. I believe this is because it is designed for voice/phone (and emergency) use, and not as part of the music/stereo sound system. The center speaker is actually really nice when listening to podcasts, rather than music. Therefore I designed a solution with an L-PAD to tune the speaker up or down, depending on what I'm listening to. This way it remains connected and available for when I want it, or not. For the L-PAD, here's the part I used: https://www.amazon.com/gp/product/B0002KR1EQ/
There are special wrench and nob parts in the parts list for use with this specific L-PAD.
Print Guidance
Choose ASA, PETG, PC, or something high-temperature. Avoid PLA: it will melt or deform in the van on a warm day.
When 3D printing any of switch panel parts, use supports on the flexible "spring" fingers. Enable supports on the build plate.