1 / 2
Doctor Doom Keychain — Hooded Mask, 0.2 mm Detail — zdjęcie 1
1 / 2

Doctor Doom Keychain — Hooded Mask, 0.2 mm Detail

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The hood, the mask, the scowl.

Ocena
5 / 5
Polubienia
3
Pobrania
29
Wydruki
1
Wyświetlenia
80
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Standard Digital File License

The hood, the mask, the scowl.

A hooded Doctor Doom keychain where the cowl actually behaves like cloth — it folds over the brow,

throws a shadow across the eyes and falls into a collar at the back, instead of being a smooth

shell stuck to a head. The riveted mask underneath keeps its hard edges against all that softness,

which is the whole point of the design. The loop prints as part of the hood.

Why you will like it

- Cloth against metal — the folded hood and the flat riveted faceplate play off each other — both

survive at 50 mm because the model was drawn for a 0.2 mm nozzle.

- One piece, no assembly — loop included, no glue, no supports to dig out of the face.

- Deep shadow line — the hood overhangs the eyes far enough to shade them, so the face reads even

in a plain single colour.

- Pocket-sized — about 50 mm tall — a solid, chunky charm on keys or a bag.

- Paints itself — a green hood over a raw metal faceplate needs nothing more than two colours and a

wash.

Print settings

- Nozzle: 0.2 mm — this is the one setting that matters. The whole model is built around a 0.2 mm

nozzle: the panel lines, the rivets on the faceplate and the loop all come out crisp. A 0.4 mm

nozzle prints it, but the fine detail turns mushy and the smallest cuts close up completely.

- Layer height: 0.1 mm (first layer 0.1 mm as well)

- Walls: 4 · Top shell: 7 layers · Infill: 15 % grid

- Supports: tree (auto), slim style, threshold 30°. The hood overhangs the whole face, so supports

are not optional here. Tree supports reach under the cowl and pull out from the front without

marking the mask.

- Brim: auto · Raft: none

- Material: PLA. Silk and matte both look good; matte hides the layer lines best.

- Outer wall around 120 mm/s. Slower does not buy you much at 0.1 mm, but a clean, well-levelled

first layer does

Tagi