SCX30 6.5ETE Flex Blades V2 (9/29 update)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printable flex blades to extend your SCX30 suspension.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 287
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Standard Digital File License
A second version of SCX30 blades. I extended the frame stop by the shock mount to prevent overcompression and jamming up at the frame. Same geometry as the early version except for that change.
These work in PLA or PETG. But they are tiny, so bed adhesion and filament choice is going to affect successful printing a lot. I used M1.4x4mm fasteners for the frame mount hole. The shock end just uses the original stud. Given the tiny holes you may want to adjust hole compensation. That said, even with tight fits for the shock stud into the blade, I just pressed hard and tightened without reprinting.
These are directional. Pay close attention to the size and orientation of the frame stops! The shorter blades are for the front. The shock stud installs to the flat side and thru the hole that has an inward facing frame stop.
Do NOT over tighten the frame bolt or the blade won't move freely. At this scale, even a quarter turn either direction can make all the difference.
Enjoy! And any feedback welcome. I have several more versions simmering, so happy to make adjustments.