Frog Case | Water-Resistant Lighter & Joint Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I saw some other lighter + cigarette cases out there and decided I needed a waterproof, or at least water-resistant,…
- Ocena
- 5 / 5
- Polubienia
- 111
- Pobrania
- 654
- Wydruki
- 3
- Wyświetlenia
- 2758
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
I saw some other lighter + cigarette cases out there and decided I needed a waterproof, or at least water-resistant, case. I call it the Frog Case because when opened the inside holes make a sort-of frog face. I don't smoke tobacco cigarettes so I can't vouch for it, but hand-rolled things should be fine
The gaskets can be made from TPU or other flexibles, I did the body in PLA+.
v1.4 - Newest version has the optimal lip height for the connection parts. Added a cap variant with a hole for connecting a cord or clip.
v1.5 - Lip is now much thicker, much less likely to break. There is also a 'leash' for the cap incorporated into the body gasket so you don't lose it. An o-ring type seal was added to the body/cap connection for a better seal
v1.6 - Now the body and cap have notches for the gaskets to sit flush inside and do not require any glue to stay put. This is likely the final version or very close to it.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
No
Resolution:
150
Infill:
35
Filament: Jayo PLA+ White
Notes:
V1.6 is scaled correctly, ensure you enable thin walls and print with .4mm or smaller
Post-Printing
I suggest using E6000 or shoe-goo to attach the gaskets so they stay. the body gasket doesn't like to hug the curves so press them down as it is gluing and it will look perfect.
How I Designed This
I created this in Fusion 360 to learn the program
Category: Other