IKEA VESKEN - STRONG Swivel Castor Mounts for IKEA ALEX Swivel Castors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
IKEA VESKEN Swivel Castor Mounts that can support fully loaded shelves. Designed to mount IKEA ALEX swivel castors.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 115
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
STRONG Ikea VESKEN swivel castor mounts for Ikea ALEX swivel castors. A VESKEN fully loaded with 3d printer filaments is HEAVY! Trying to design strong swivel castor mounts is difficult because the VESKEN plastic legs flex.
NOTE: This was designed for the Ikea VESKEN in the pictures. I am not sure if the mounting holes will align with other VESKEN models.
You can use PLA for the mounts.
These swivel castor mounts are fastened to the bottom of the bottom shelf. Locator washers are used to keep the mount rigid.
You will need:
1) QTY 4 Ikea ALEX swivel castors or any castor with 32mm spaced mounting holes.
2) QTY 12 M3x20mm screws along with washers and nuts. This is to mount plate to bottom shelf.
3) QTY 16 M3 thread heat inserts
4) QTY 16 M3x8mm screws to mount castors to castor mount
Installation:
Installation:
1) Install the M3 threaded heat inserts into each mount
2) Using a hammer lightly tap off bottom shelf. Discard stock feet and stationary castor.
3) There are 2 left mounts and 2 right mounts. With bottom shelf disassembled and on worktable, install them into bottom shelf of VESKEN
LEFT MOUNT: Left side of skinny end when VESKEN is upside down

RIGHT MOUNT: Right side of skinny end when VESKEN is upside down

4) With bottom shelf on worktable, press the locating washers through shelf and embed into castor mounts.
5) For each castor mount, install QTY3 M3x20mm screws, washers, and nuts through locating washers. Tighten mount to bottom shelf.
6) Install bottom shelf onto VESKEN.
7) Install QTY 4 swivel castors with QTY16 M3x8mm screws.