1 / 5
Greenworks drill or driver bit holder — zdjęcie 1
1 / 5

Greenworks drill or driver bit holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A bit holder for the side of your Greenworks drill or driver. Holds two bits

Ocena
0 / 5
Polubienia
5
Pobrania
14
Wydruki
0
Wyświetlenia
64
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

This is a bit holder for the side of your Greenworks 24v drill or driver.  It holds two screwdriver bits (single ended or double ended).  It is based on a design by lllars on Thingiverse for a different drill.  There are little nubs in the slots to secure the bits. 

The green one in some of the pictures is green Jayo PETG I was testing.  I printed another with black ASA. 

Supports are probably needed in the hole (see pictures).  You could print this in PLA if it doesn't need to go outside or in a hot car.  ASA might be better in a hot car although PETG should work for most.  I used 8 walls/perimeters and supports "everywhere" but it should work with basic settings. 

You will need one M4 screw about 10-12mm long to install it.  There is a right side or left side version.  If you are right handed you probably want the right side regular version.

Thanks to lllars for the original I based this on.

Tagi