AceMagic AK1 Plus 120mm Fan Spacer (N95 cooling sandwich)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacer ring between the AK1 Plus shells fitting a quiet 120mm fan: NVMe 70C to 39C. Fits AK2 Plus clones too.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 74
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A spacer ring that goes between the original bottom and top shells of an AceMagic AK1 Plus (Intel N95) mini PC and fits a quiet 120mm fan blowing down onto the board. It fixes the chronic thermal throttling of this machine without giving up the original case, ports, buttons or LED lid. Should also fit the AK2 Plus clones (Kamrui, Firebat, NiPoGi) built on the same AK1_ADN mainboard - verify the footprint with the included test files first.
Measured on a 24/7 homelab server (Prometheus, 6h averages): NVMe controller went from 69-73 C (84 under load) to 38-40 C. CPU package from 63-65 C to 45-49 C. Thermal throttle events from about 4 million in 3 days to about 400 in 2 days.
Bill of materials: Noctua NF-F12 5V PWM or any true-5V 120mm fan (12V fans will not spin from the board header), 4x M3x40-42 bolts (cut M3x50 works, max 44mm), 4x M3 heat-set inserts 5mm OD x 6mm, 4x M3x10 self tappers for the lid, a 2-pin JST XH pigtail for 5V from the J5 header (verify 5V with a multimeter first), and an M.2 2280 heatsink for the NVMe.
Printing: PETG recommended, 0.2mm layers, 3 walls, 25-30% infill, NO supports - both parts are exported in their print orientation. The 45 degree louvres are self supporting with no bridges. Limit retractions in your slicer (Cura: Maximum Retraction Count 10, Minimum Extrusion Distance Window 6.5) or a bowden extruder may chew the filament.
Assembly order matters: cut the lid posts to ~3-5mm past the seating plane, melt the inserts into the shelves, screw the lid to the top part from inside, seat the fan on the bottom collar with arrows pointing down, then bolt everything together from below through the fan's own corner channels into the inserts. The stock LED PCB (17x30) lies in a dedicated tray on the top flange, its connector rising through the pass-through slot, glowing through the lid grille as stock.
The full parametric OpenSCAD source (spacer.scad + the scanned case profile) is included: every dimension is a named parameter, so clone variants only need a couple of edits.